Table of Contents
Advertisement
Figure 128. Installing the left control panel
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
Removing the right control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. You must route
the cables properly when you replace them to prevent the cables from being pinched or crimped.
3.
Remove the air
shroud.
Steps
1. Disconnect the right control panel cable from the connector on the system board.
2. Open the blue cable retention latch and disconnect the VGA cable from the connector on the system board.
3. Using a Phillips #1 screwdriver, remove the screws that secure the right control panel assembly.
4. Hold the right control panel assembly and remove it from the system.
140
Installing and removing system components
After working inside your system
Safety instructions
Before working inside your system
on page 44.
on page 43.
on page 44.
Advertisement
Table of Contents
