2. Follow the procedure listed in the
3.
Remove the air
shroud.
Steps
1. Align and insert the intrusion switch in the slot until it is firmly seated in the slot on the chassis.
NOTE:
Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
2. Connect the intrusion switch cable to the connector on the system board.
Figure 37. Installing the intrusion switch
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
Drives
Removing a drive blank
Prerequisites
1. Follow the safety guidelines listed in the
2. If installed,
remove the front
CAUTION:
To maintain proper system cooling, drive blanks must be installed in all empty drive slots.
CAUTION:
Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Steps
Press the release button, and slide the drive blank out of the drive slot.
Before working inside your system
After working inside your system
Safety instructions
bezel.
on page 44.
on page 44.
on page 43.
Installing and removing system components
61