Table of Contents
Advertisement
Installing the right control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Steps
1. Align and slide the right control panel in the slot on the system.
2. Connect the right control panel cable to the connector on the system board.
3. Route the right control panel cable through the side wall of the system. Close the cable latch and slide the cable into the clip.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
4. Using the Phillips #1 screwdriver, tighten the screws that secure the right control panel to the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 20. Installing the right control panel
Next steps
1.
Install the drive backplane
2. If removed,
install the air
3. Follow the procedure listed in
Removing the left control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed,
remove the air
Safety
instructions.
Before working inside your
cover.
shroud.
After working inside your
Safety
instructions.
Before working inside your
shroud.
system.
system.
system.
Installing and removing system components
47
Advertisement
Table of Contents
