Installing The Right Control Panel - Dell EMC PowerEdge R340 Installation And Service Manual

Figure 80. Removing the right control panel
Next steps
1. Replace the right control

Installing the right control panel

Prerequisites
1. Follow the safety guidelines listed in
Steps
1. Route the control panel cable through the side wall and the guide slots in the system.
NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
2. Align and insert the right control panel assembly in the slot on the system.
3. Using the appropriate screwdriver, fasten the screws that secure the right control panel assembly.
4. Connect the control panel cable to the connector on the system board.
panel.
Safety instructions.
PowerEdge R340 installing and removing system components 95