Table of Contents
Advertisement
Figure 24. Removing the right control panel
Next steps
1.
Replace the right control
Installing the right control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Steps
1. Align and slide the right control panel in the slot on the system.
2. Connect the right control panel cable and VGA cable to the connectors on the system board.
3. Route the right control panel cable through the side wall of the system. Align and slide the right control panel cable cover in the slot on
the system.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
4. Using the Phillips #1 screwdriver, tighten the screws that secure the right control panel and the right control panel cable cover to the
system.
54
Installing and removing system components
panel.
Safety instructions
Before working inside your system
on page 46.
on page 47.
Advertisement
Table of Contents
