Table of Contents
Advertisement
Figure 127. Removing the left control panel
Next steps
1.
Replace the left control
Installing the left control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
Steps
1. Route the left control panel cable through the chassis sidewall.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
2. Align and insert the tabs on the left control panel assembly into the slots on the chassis.
3. Using a Phillips #1 screwdriver, replace the screws to secure the left control panel assembly to the chassis.
4. Connect the left control panel cable to the connector on the system board.
panel.
Safety instructions
Before working inside your system
on page 43.
on page 44.
Installing and removing system components
139
Advertisement
Table of Contents
