Figure 43. Removing right control panel
Next steps
1.
Replace the right control
Installing the right control panel
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the front
bezel.
4.
Remove the support
bar.
5.
Remove the air
shroud.
6.
Remove the cooling fan
Steps
1. Route the control panel cable through the side wall of the system.
2. Align the control panel assembly with the control panel slot on the system and place the assembly in the slot on the system.
3. Connect the VGA cable to the system board.
4. Connect the control panel cable to the system board connector and secure it using cable latch.
5. Using a Phillips #1 screwdriver, install the screws that secure the control panel and ribbon cable to the system.
panel.
Safety
instructions.
Before working inside your
assembly.
system.
Installing and removing system components
67