Intel R2000WT Series System Integration And Serive Manual page 25

Intel ® Server System R2000WT Product Family System Integration and Service Guide
1.3.1 8 x 2.5" Front Drive Bay Module Installation (Intel® Server Chassis
R2000WTxxx and Intel® Server System R2208WTxxxx)
Continue with the instructions in this section for installation of several available 8 x 2.5" front drive bay
accessory kits into the system. If an 8 x 3.5" front drive bay module accessory kit is being installed, proceed
to section 1.3.4.
Remove Drive Bay Retention Bracket
• To extract the drive bay retention bracket, remove the 6 fastener screws from the top front edge of the
drive bay and pull out the metal bracket. Set aside the retention bracket and screws for re-installation at
a later time.
Remove Drive Bay Filler Panel(s)
The chassis includes a drive bay filler panel for each drive bay location that doesn't have a drive bay pre-
installed. Remove a filler panel for each 8 x 2.5" drive bay module being installed.
Carefully place the chassis on its side.
•
From the bottom of the chassis, remove the fastener screw securing the drive bay filler panel (see letter
•
'C')
• Carefully return the chassis to its original position
Slide out the drive bay filler panel (see letter 'D')
•
Figure 7. R2000WTxxx Drive Bay Retention Bracket Removal
9