Intel R2000WT Series System Integration And Serive Manual page 112

Intel ® Server System R2000WT Product Family System Integration and Service Guide
7.4.2 Standard Front Control Panel Installation (R2208WTxxx &
R2216WTxxx)
• Locate and remove the replacement control panel board from its packaging - Intel Product Code -
FXXFPANEL
• Connect the 30-pin ribbon cable to the new control panel
Install the control panel board into the back of the drive bay module (see letter 'A')
•
Note: Ensure the plastic gasket over the control panel buttons is securely in place before installing the
control panel board into the drive bay module.
The control panel is properly positioned when the buttons are protruding from the Control Panel face
•
plate on the front of the drive bay module and the screw holes on the top of the assembly are aligned.
Using a single screw, secure the Control Panel Assembly to the drive bay module (8 in/lbs torque) (see
•
letter 'B')
Ensure the Control Panel cable is securely attached to the control panel board
•
Install the I/O Bay Module into the chassis (see letter 'A')
•
96