Intel R2000WT Series System Integration And Serive Manual page 106

Intel ® Server System R2000WT Product Family System Integration and Service Guide
7.1 Replacing the System Battery
The battery on the server board powers the Real Time Clock for up to 10 years in the absence of power.
When the battery starts to weaken, it loses voltage, and stored server settings and system clock and date
settings maybe lost.
Battery Specification:
Lithium
•
3V
•
Coin CR-2032
•
Contact your customer service representative or dealer for a list of approved devices.
Warning: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type
recommended by the equipment manufacturer. Discard used batteries according to manufacturer's
instructions.
Advarsel: Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering. Udskiftning må kun ske med batteri af
samme fabrikat og type. Levér det brugte batteri tilbage til leverandøren.
Advarsel: Lithiumbatteri - Eksplosjonsfare. Ved utskifting benyttes kun batteri som anbefalt av
apparatfabrikanten. Brukt batteri returneres apparatleverandøren.
Varning: Explosionsfara vid felaktigt batteribyte. Använd samma batterityp eller en ekvivalent typ som
rekommenderas av apparattillverkaren. Kassera använt batteri enligt fabrikantens instruktion.
Varoitus: Paristo voi räjähtää, jos se on virheellisesti asennettu. Vaihda paristo ainoastaan laitevalmistajan
suosittelemaan tyyppiin. Hävitä käytetty paristo valmistajan ohjeiden mukaisesti.
• Locate the battery on the server board.
Gently press the metal clip as shown to release the battery (see letter "A").
•
• Remove the battery from the plastic socket (see letter "B").
Dispose of the battery according to local ordinance.
•
• Remove the new lithium battery from its package, and, being careful to observe the correct polarity,
insert it in to the battery socket.
Note: The <F2> BIOS Setup Utility must be accessed and setting must be set and saved to restore configuration settings
90
Figure 100. Replacing the Backup Battery