Display Of The Current Charge Level Using The Cockpit App; Display Of The Current Charge Level During The Charging Process; Display Of Current Charge Level Using Remote Control (Optional Accessory); Preparation For Use - Otto Bock Genium Series Instructions For Use Manual

6.3.2 Display of the current charge level using the Cockpit app

Once the Cockpit app has been started, the current charge level is displayed in the bottom line of the screen:

6.3.3 Display of the current charge level during the charging process

During the charging process, the current battery charge level is indicated by the LEDs lit on the side of the char­
ger.

6.3.4 Display of current charge level using remote control (optional accessory)

Only when "DUAL" marking is not present (see Page 66)
The current charge level is displayed in the status bar of the remote control when it is connected and switched on:

7 Preparation for use

7.1 Alignment

Only valid for the products 3B1-2/3B1-2=ST
The following alignment guidelines contain descriptions for connecting the knee joint to a prosthetic socket. In
principle, the alignment of the prosthesis is independent of the type of connection for the knee joint. In case of a
connection to an osseointegrated, percutaneous implant system, a socket is not used during bench alignment in
the alignment apparatus. In this case, the central proximal point on the prosthetic socket corresponds to the
trochanter of the thigh bone (see illustration in the section "Bench alignment in the alignment apparatus" see
Page 83).
Ensure that possible flexion or adduction of the transfemoral residual limb can be compensated to a permissible
extent by an adapter approved by the implant manufacturer in the course of static alignment optimisation. Safe
functioning of the knee joint is only guaranteed with biomechanically correct alignment.

7.1.1 Settings with the "X-Soft" adjustment software

7.1.1.1 Introduction

The "X-Soft" adjustment software makes it possible to optimise the product settings for a patient. The adjustment
software provides step-by-step guidance through the adjustment process. After the settings are configured, the
data for them can be saved and printed for documentation. If needed, these data can be loaded and fed into the
product.
You can consult the integrated online help of the adjustment software for further information.
INFORMATION
The 4X1 X-Soft adjustment software, version 1.8 or higher is required for correct alignment. If X-Soft is on
hand in a version of 1.0 or higher, it can be updated.
1. 38% – Charge level of battery for currently connected component
1. – Charge level of battery for currently connected prosthesis
– Prosthesis is being charged
2. 68% – Charge level of battery for currently connected prosthesis, as a
percentage
Quantity Battery charge level
0
1
2
3
4
5
Preparation for use
0%-10%
10%-30%
30%-50%
50%-70%
70%-90%
> 90%
81