Deleting A Component; Connecting Component With Multiple Devices; Use; Movement Patterns In Basic Mode (Mode 1) - Otto Bock Genium Series Instructions For Use Manual

INFORMATION
If establishing a connection to a component is not possible, perform the following steps:
► Delete the component from the Cockpit app if applicable (see the section "Deleting a component")
► Add the component again in the Cockpit app (see the section "Adding a component")
Only when "DUAL" marking is present (see Page 66)
INFORMATION
After activating the "visibility" of the component (holding the component with the sole of the foot facing up, or con­
necting and then disconnecting the battery charger), the component can be recognised by another device
(e.g. smartphone) within 2 minutes. If registration or establishing the connection takes too long, the process of
establishing a connection is cancelled. In this case, hold the component with the sole of the foot facing up again,
or connect and then disconnect the battery charger.

8.4.2 Deleting a component

1) Tap the symbol in the main menu.
→ The navigation menu opens.
2) In the navigation menu, tap the entry "Manage components".
3) Tap the "Edit" button.
4) Tap the symbol under the component you want to delete.
→ The component is deleted.

8.4.3 Connecting component with multiple devices

The connection for a component can be stored on more than one device. However, only one device can be con­
nected to the component at one time.
If there is an existing connection between the component and a different device, the following information appears
while the connection is being established with the current device:
Connect to this component?
Component was connected to
another device.
Establish connection?
Cancel

9 Use

9.1 Movement patterns in basic mode (mode 1)

9.1.1 Standing

Knee control through high hydraulic resistance and static alignment.
A stance function can be enabled using the adjustment software. Please see the following
section for further information on the stance function.

9.1.1.1 Stance function

INFORMATION
To use this function, it needs to be enabled in the adjustment software. It also has to be activated using the Cock­
pit app (see Page 94).
► Tap the OK button.
→ The connection to the last connected device is broken off and estab­
lished with the current device.
OK
Use
89