Display Of The Current Charge Level Using The Cockpit App; Display Of The Current Charge Level During The Charging Process; Preparation For Use; Alignment - Otto Bock Genium X3 3B5-3 Instructions For Use Manual

Preparation for use

Beep signal
5x short
4x short
3x short
2x short
1x short
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app (see Page 37) or if mute mode (silent mode) is activated,
there are no beep signals.

6.3.2 Display of the current charge level using the Cockpit app

Once the Cockpit app has been started, the current charge level is displayed in the bottom line of the screen:

6.3.3 Display of the current charge level during the charging process

During the charging process, the current battery charge level is indicated by the LEDs lit on the side of the char­
ger.
7 Preparation for use

7.1 Alignment

The following alignment guidelines contain descriptions for connecting the knee joint to a prosthetic socket. In
principle, the alignment of the prosthesis is independent of the type of connection for the knee joint. In case of a
connection to an osseointegrated, percutaneous implant system, a socket is not used during bench alignment in
the alignment apparatus. In this case, the central proximal point on the prosthetic socket corresponds to the
trochanter of the thigh bone (see illustration in the section "Bench alignment in the alignment apparatus" see
Page 28).
Ensure that possible flexion or adduction of the transfemoral residual limb can be compensated to a permissible
extent by an adapter approved by the implant manufacturer in the course of static alignment optimisation. Safe
functioning of the knee joint is only guaranteed with biomechanically correct alignment.
26
1) Turn the prosthesis by 180° (the sole of the foot must face up).
2) Hold still for 2 seconds and wait for beep signals.
1. 38% – Charge level of battery for currently connected component
Battery charge level
more than 80%
60% to 80%
40% to 60%
20% to 40%
less than 20%
Quantity
0
1
2
3
4
5
Battery charge level
0%-10%
10%-30%
30%-50%
50%-70%
70%-90%
> 90%
Genium X3 3B5-3/3B5-3=ST