Beep signal
2x short
1x short
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app or using the remote control (see
Page 31) or if mute mode (silent mode) is activated, there are no beep signals.
7.3.2 Display of the current charge level using the Cockpit app
Once the cockpit app has been started, the current charge level is displayed in the bottom line of
the screen:
7.3.3 Display of current charge level using remote control (optional accessory)
The current charge level is displayed in the status bar of the remote control when it is connected
and switched on:
7.3.4 Display of the current charge level during the charging process
During the charging process, the current battery charge level is indicated by the LEDs lit on the
side of the charger.
8 Cockpit app
1.
thesis
1.
thesis
– Prosthesis is being charged
2. 68% – Charge level of battery for currently connected pros
thesis, as a percentage
The cockpit app enables switching from basic mode into the pre-configured
MyModes. In addition, information about the product (step counter, battery
charge level, etc.) can be called up.
The behaviour of the product can be changed to a certain extent on a day-to-
day basis using the app (e.g. while becoming accustomed to the product). At
the next appointment, the prosthetist can trace the changes using the adjust
ment software.
Battery charge level
20% to 40%
less than 20%
38% – battery charge level of currently connected pros
– Charge level of battery for currently connected pros
Quantity
Battery charge
0
1
2
3
4
5
level
0%-10%
10%-30%
30%-50%
50%-70%
70%-90%
> 90%
Ottobock | 19