Important Information For The Products 3B1/3B1=St; Important Information For The Products 3B1/3B1=St And 3B1-2/3B1-2=St - Otto Bock Genium Series Instructions For Use Manual

Important information for the products 3B1/3B1=ST

Important information for the products 3B1/3B1=ST
Only valid for the products 3B1/3B1=ST
The functional scope of products with serial numbers SN 2015 25 XXX and higher, or products that have been ser­
viced or repaired by an authorised Ottobock Service Centre since June 2015, has been extended.
Extended functional scope:
• Switching to pre-configured MyModes and changing the prosthesis settings by using the remote control or an
app for smartphones (4X441 Cockpit) (see Page 86, see Page 94). If the joint bears the marking "DUAL", the
remote control cannot be used anymore (see next section).
• Possibility of using an intentional stance function (see Page 89)
• Displays of the current battery level without additional devices (see Page 80)
• Deactivation of feedback and vibration signals (mute mode – see Page 96)
• Stance, sitting, and stairs function can be switched off (see Page 94)
• Bluetooth function can be switched off (see Page 96)
• Preparing an activity report using the adjustment software (optionally available)
INFORMATION
Remote control function only possible with version 1.0.0.6 or above
Please note that you can only use this knee joint and the updated one with the 4X350 remote control in version
1.0.0.6 and higher.
Therefore, check the version of the remote control as follows:
► With the remote control switched on, use the
firm with the key.
keys to select the menu option Info and confirm this with the key.
► Use the and
keys to select the RC version: 1.0.0.4 menu option. If an older version appears than 1.0.0.6,
► Use the and
the remote control must be updated by an authorised Ottobock Service Centre.
The function of the remote control with this or the updated knee joint is only possible with version
1.0.0.6 or higher.

Important information for the products 3B1/3B1=ST and 3B1-2/3B1-2=ST

INFORMATION
Adjustment of the knee joint possible only with X-Soft 4X1 version 1.8 and higher
Please note that you need X-Soft 4X1 version 1.8 or higher in order to adjust this knee joint or the updated one. If
X-Soft version 1.0 or higher is available, it can be updated (see Page 81)
Using the 4X350 remote control is no longer possible on products with the marking "DUAL"
66
keys to select the menu option RC settings and con­
and