Charging The Prosthesis Battery; Display Of The Current Charge Level; Display Of Battery Charge Level Without Additional Devices; Display Of The Current Charge Level Using The Cockpit App - Otto Bock C-Leg 3C98-3 Instructions For Use Manual

Hide thumbs Also See for C-Leg 3C98-3:
Table of Contents

Advertisement

6.2 Charging the prosthesis battery

6.3 Display of the current charge level

INFORMATION
The charge level cannot be displayed during the charging process.

6.3.1 Display of battery charge level without additional devices

Beep signal
5x short
4x short
3x short
2x short
1x short
1x short
INFORMATION
A familiar tune sounds instead of the beeps
If this tune sounds, this indicates that the rules for controlling the prosthesis were loaded correctly and the pros­
thesis is ready for operation.
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app, there are no beep signals (see page 39).

6.3.2 Display of the current charge level using the Cockpit app

Once the Cockpit app has been started, the current charge level is displayed in the bottom line of the screen:
C-Leg 3C98-3/3C88-3
1) Open the charging receptacle cover (open up the flap or push the slider up).
2) Connect the charging plug to the charging receptacle of the product.
INFORMATION: Make sure to insert it in the right direction!
A low insertion force has to be overcome during connection so the char­
ging plug remains reliably connected to the charging receptacle.
→ A correct connection between the battery charger and the product is indic­
ated by feedback (see page 51).
3) The charging process starts.
→ Once the product battery is fully charged, the yellow LED on the battery
charger turns off.
4) Disconnect the product after the charging process is complete.
INFORMATION: A low separating force between the charging plug and
charging receptacle has to be overcome to disconnect the plug.
→ A self-test is performed. The product is ready for operation only after corre­
sponding feedback (see page 53).
5) Close the charging receptacle cover.
1) Rotate the prosthesis 180° (the sole of the foot must face up).
2) Hold still for 2 seconds and wait for beeps.
Vibration signal
3x long
5x long
Charging the battery
Battery charge level
more than 80%
65% to 80%
50% to 65%
35% to 50%
20% to 35%
less than 20%
25

Advertisement

Table of Contents
loading

This manual is also suitable for:

C-leg 3c88-3

Table of Contents