Display Of The Current Charge Level Using The Cockpit App; Display Of The Current Charge Level During The Charging Process; Display Of Current Charge Level Using Remote Control (Optional Accessory) - Otto Bock Genium X3 Series Instructions For Use Manual

Beep signal
5x short
4x short
3x short
2x short
1x short
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app (see Page 84) or if mute mode (silent
mode) is activated, there are no beep signals.

8.3.2 Display of the current charge level using the Cockpit app

Once the Cockpit app has been started, the current charge level is displayed in the bottom line of
the screen:

8.3.3 Display of the current charge level during the charging process

During the charging process, the current battery charge level is indicated by the LEDs lit on the
side of the charger.

8.3.4 Display of current charge level using remote control (optional accessory)

Only when "DUAL" marking is not present (see Page 60)
The current charge level is displayed in the status bar of the remote control when it is connected
and switched on:
Battery charge level
more than 80%
60% to 80%
40% to 60%
20% to 40%
less than 20%
1. 38% – Charge level of battery for currently connected
component
1. – Charge level of battery for currently connected pros­
thesis
– Prosthesis is being charged
2. 68% – Charge level of battery for currently connected pros­
thesis, as a percentage
Quantity Battery charge
0
1
2
3
4
5
level
0%-10%
10%-30%
30%-50%
50%-70%
70%-90%
> 90%
75