Display Of The Current Charge Level Using The Cockpit App; Display Of Current Charge Level Using Remote Control (Optional Accessory); Display Of The Current Charge Level During The Charging Process; Preparation For Use - Otto Bock Genium 3B1 Instructions For Use Manual

Beep signal
5x short
4x short
3x short
2x short
1x short

7.3.2 Display of the current charge level using the Cockpit app

Once the cockpit app has been started, the current charge level is displayed in the bottom line of the screen:

7.3.3 Display of current charge level using remote control (optional accessory)

The current charge level is displayed in the status bar of the remote control when it is connected and switched on:

7.3.4 Display of the current charge level during the charging process

During the charging process, the current battery charge level is indicated by the LEDs lit on the side of the char­
ger.

8 Preparation for Use

8.1 Alignment

INFORMATION
The 4X1 X-Soft adjustment software , version 1.4 or higher is required for correct alignment. If X-Soft is on
hand in a version of 1.0 or higher, it can be updated.
Genium 3B1/3B1=ST
1) Turn the prosthesis by 180° (the sole of the foot must face up).
2) Hold still for 2 seconds and wait for beep signals.
1. 38% – battery charge level of currently connected prosthesis
1. – Charge level of battery for currently connected prosthesis
– Prosthesis is being charged
2. 68% – Charge level of battery for currently connected prosthesis, as a
percentage
Battery charge level
more than 80%
60% to 80%
40% to 60%
20% to 40%
less than 20%
Quantity
0
1
2
3
4
5
Preparation for Use
Battery charge level
0%-10%
10%-30%
30%-50%
50%-70%
70%-90%
> 90%
Ottobock | 67