Accessories; Charging The Battery; Connecting The Power Supply And Battery Charger - Otto Bock Genium Series Instructions For Use Manual

• 1 pc. 757L16* power supply
• 1 pc. 4E60* inductive charger
• 1 pc. 4H99 7.5° Genium flexion stop
• 1 pc. Genium 4H100 15° flexion stop (already
installed on delivery)
• 1 pc. 4X259 installation ring for inductive charger
• 2 pc. M3x5 Torx screws (as replacement for the
installed screws of the flexion stop)
• 1 pc. T10 Torx bit
• 1 pc. cosmetic case for battery charger and power
supply
Only when "DUAL" marking is present (see Page 66)
• iOS app "4X441-IOS=V* Cockpit" for download from the website: http://www.ottobock.com/cockpitapp

5.2 Accessories

The following components are not included in the scope of delivery and may be ordered separately:
• 4X880=* Genium Protective Cover
• 4H103 Genium 22.5° flexion stop
• 3S26 cosmetic foam cover
• 3F1=2
Only when "DUAL" marking is not present (see Page 66)
• 4X350 remote control
The user interface is available in the following languages: German, English, French, Italian, Spanish, Dutch,
Swedish

6 Charging the battery

The following points must be observed when charging the battery:
• With average use, the capacity of the fully charged battery is sufficient for about 5 days.
• We recommend charging the product once a day when used by the patient on a daily basis.
• When used daily, the complete charging unit (power supply – battery charger) may remain plugged into the
wall socket.
• The battery should be charged for at least 3 hours prior to initial use.
• Note the permissible temperature range for charging the battery (see Page 103).
• Use the 757L16* power supply and 4E60* battery charger to charge the battery.
• The distance between the battery charger and the receiver on the product must not exceed 2 mm.
• The tube adapter must be connected before disconnecting the battery charger, otherwise an error message
will result (see Page 107).

6.1 Connecting the power supply and battery charger

1
1) Slide the country-specific plug adapter onto the power supply until it locks into place (see fig. 1).
2) Connect the round, three-pin plug of the power supply to the receptacle on the battery charger (see fig. 2) so
that the plug locks into place.
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting the cable plug
to the battery charger.
• 1 pc. 646C107 Bluetooth PIN card
• 1 pc. 647F542 prosthesis passport
• 1 pc. card holder for prosthesis passport
• 1 pc. 647G1389 instructions for use (qualified per­
sonnel)
• 1 pc. 647G1387, 647G1387=1 instructions for use
(user)
• Android app "Cockpit 4X441-Andr=V*" for down­
load
http://www.ottobock.com/cockpitapp
• 4X258 installation tool for inductive charger
• "X-Soft 4X1=V1.8" or higher adjustment software
Update from 4X1=V1.0, V1.2, V1.6 with Internet
download
2
Charging the battery
from the
3
website:
79