Adjusting The Position Of The Sensing Spindle/Liner - Sacmi PMV 224 Maintenance And Operation Manual

176.12
.A03
ADJUSTMENTS
7
7.5.3

ADJUSTING THE POSITION OF THE SENSING SPINDLE/LINER

The liners are always checked on the outermost part. The height of the sensing spindle in relation to the liner must
be adjusted in the area of the unit illustrated in the diagram. A comparator with a magnetic base and a complete set
of sample caps must be available.
- Position the comparator (1) so that it can detect the vertical movement of the sensing spindle in the area where the
adjustment is to be made, as indicated in the diagram.
- Place a cap under the sensing spindle (2) as shown in the illustration. Each sensing spindle should be adjusted by
using sample caps which are stamped with the number of the forming plunger that the spindle controls during the
production stage.
- Reset the comparator (1) with the cap placed under the sensor. Check that the roller (5) rests on the cam (6).
- Loosen the screw (3)
- Turn the cam (4) until the comparator indicates an upwards movement of approx. 0.1 mm.
- Tighten the screw (3) again.
- Remove the cap from under the spindle (2).
Adjust the rest of the spindles in the same way.
FIGURE 7.5.3 - ADJUSTING THE POSITION OF THE SENSING SPINDLE/LINER
7 - 20
Revision 01 Date 14.11.2001
•
1
3
4
2
U
S
1 Comparator
2 Sensing spindle
5
3 Screw
6
4 Cam
5 Roller
6 Cam
°
2 T 2nd transfer unit
F Forming unit
S Quality control unit
U Discharge unit
Z Area where the adjustments
are to be made
2°T
Z
F
T0437
T0465