176.12
.A03
8
MAINTENANCE
8.2.1.2
Timing the 1st turntable/insertion drum
- Place the centering ring (7) within two teeth of the first turn-table (2).
- Using the handwheel, run the first turn-table until the space which holds the centering ring (7) is brought to the point
where the caps are passed from the turn-table to the insertion drum (1) grippers.
- The insertion drum's gripper must perfectly coincide with the centering ring in the point mentioned above.
If it does not happen:
- loosen the bolts (9) which hold the gear wheel (11) in place;
- turn the insertion drum assembly, which is integral with the turn-table, until the correct position is reached;
- fully tighten the bolts (9).
8.2.1.3
Timing the forming drum/2nd turn-table
Proceed as directed for the 1st turn-table in the paragraph TIMING THE FORMING UNIT/1ST TURNTABLE.
FIGURE 8.2.1.2 - TIMING THE 1ST TURNTABLE/INSERTION DRUM
1
Insertion drum
2
1st transfer turntable
7
Centering ring
9
Bolt
11 Gear wheel
8 - 20
Revision 01 Date 14.11.2001
7
2
11
9
1