Adjustments; Adjusting The Extruder - Sacmi PMV 224 Maintenance And Operation Manual

7

ADJUSTMENTS

7.1

ADJUSTING THE EXTRUDER

Adjusting the work parameters
The parameters that can be adjusted are given on the "Extruder" page of the electronic control system.
These parameters include the following:
- Temperature in the heated areas
- Extruder motor speed % (available only for operations in manual mode)
- Coolant temperature
The values for these parameters are given on the "Data sheet".
ATTENTION!
E0004P
- Consult the Instructions B manual that deals with the control system for information on how to set the parameters.
Revision 01 Date 14.11.2001
176.12
ADJUSTMENTS
.A03
7
7 - 1