Cutter Height Adjustment - Sacmi PMV 224 Maintenance And Operation Manual

176.12
.A03
ADJUSTMENTS
7
7.2.1

CUTTER HEIGHT ADJUSTMENT

- Position the three comparators (6) at 120° on the cam (1) as shown in the diagram (in zones 4).
- Set the comparators (6) to "zero".
- Loosen the screws (2).
- Loosen or tighten the grub screws (3) to raise or lower the cam (1). Make sure the comparators give the same readings.
- Since the spindles (5) are attached to the cam (1), they are raised or lowered to the same degree as indicated by
the instrument.
To measure the correct distance between the cutter and the bottom of the cap, use the lower surface of the transfer
wheels as a reference. However they are 6 mm higher, as shown in figure 7.2.
FIGURE 7.2.1 - POSITION OF THE COMPARATORS
4
1
2
5
1 Cam
2 Screws
3 Grub screws
4 Position of the comparators
5 Spindles
6 Comparator
7 - 8
Revision 01 Date 14.11.2001
6
•
•
•
•
4
•
4
3
T0424