Insertion Drum Adjustment - Sacmi PMV 224 Maintenance And Operation Manual

7.2

INSERTION DRUM ADJUSTMENT

The correct distances between the cutter and the bottom of the cap (T) as well as between the central plunger and
the bottom of the cap (P) have to be determined in order for the machine to operate properly.
Normally these parameters are determined during machine commissioning, as the type of plastic compound used, the
weight of the pellets and the varnish applied are extremely important factors capable of affecting the whole process.
If it is necessary to change the heights "P" and "T" perform the operations described below.
FIGURE 7.2 - CUTTER
T Cutter height
P Plunger height
Revision 01 Date 14.11.2001
176.12
ADJUSTMENTS
.A03
7
T2444
7 - 7