Centering The Pellets - Sacmi PMV 224 Maintenance And Operation Manual

176.12
.A03
ADJUSTMENTS
7
7.2.5

CENTERING THE PELLETS

In order to obtain good quality liners, the pellets must be perfectly centered.
The cutter can be shifted radially in relation to the drum.
Five position are available with movements ranging from "zero" to 1 mm.
The positions are numbered and all the cutters must be placed at the corresponding number.
To adjust, proceed as directed below:
- Loosen and remove the screw (A) from the side opposite the rod.
- Turn the flange (B) moving the pointer to the desired number.
- Fully tighten the screws (A).
Generally speaking, the movement (C) indicated in the figure along with the other work parameters are determined
during machine testing as the type of plastic compound used and weight of the pellets greatly affect them.
FIGURE 7.2.5 - CUTTER WITH SIDE ADJUSTMENTS
A Screw
B Flange
C Side movement
7 - 12
Revision 01 Date 14.11.2001
A
B
C
T1059