Handling The Machine Parts - Sacmi PMV 224 Maintenance And Operation Manual

176.12
.A03
INSTALLATION
4
4.1.3

HANDLING THE MACHINE PARTS

When the parts are received by the end-user they must be handled with the greatest care and lifted both on the inside
and outside with equipment having an adequate lift capacity.
The best systems for lifting and handling the heaviest and bulkiest parts as well as those that require special care or
tools provided by Sacmi are shown in the figure.
When lifting the smaller parts and packages, take great care, use the most suitable equipment and observe all safety
precautions.
WARNING!
E0004P
All lifting and handling operations are to be carried out by authorised and trained personnel only.
All persons should stay well clear of suspended loads and the range of action of the lifting system while the machine
is being moved.
- Carefully follow the instructions given in Chapter 3 - SAFETY EQUIPMENT AND PRECAUTIONS.
WARNING!
E0004P
The manufacturer shall not be held responsible for any injury to personnel or damage to the machine resulting from
failure to observe the safety standards regarding the handling and lifting of materials in use at the user's factory.
FIGURE 4.1.3 - HANDLING THE MACHINE PARTS
1 Drum base
L
4 - 4
Revision 01 Date 14.11.2001
2 Extruder base
C
C
T0356
L 2280 mm long sling
C 2225 mm long sling
6 Electrical cabinet
L
C
T2438
T0360