Work Cycle - Sacmi PMV 224 Maintenance And Operation Manual

6.2

WORK CYCLE

FIGURE 6.2 - WORK CYCLE
1st Rej.
1°Sc.
10
1 The caps are fed continuously (facing the right way up and in lines) to the insertion drum.
2 Insertion drum: sprue cut (if present in the cap); pellet placed in caps
3 Plastic compound feed hopper
4 Plastic compound extruder
5 First transfer unit
6 Forming unit: the liners are formed inside the caps
7 Second transfer unit and cap cooling
8 Quality control unit: caps checked with a pneumatic/mechanical system
9 Discharge unit
10 Exit channel and cap counter
1st Rej. Caps rejected because defects detected by vision system (if installed).
2nd Rej. Caps rejected because of defects detected by pneumo-mechanical system and sensor that detects
double liners
Revision 01 Date 14.11.2001
2°Sc.
2nd Rej.
1
9
8
7
6
OPERATING INSTRUCTIONS
2
5
176.12
.A03
3
4
6
T0601
6 - 5