Adjusting The Height Of The Sensing Spindles - Sacmi PMV 224 Maintenance And Operation Manual

7.5.2

ADJUSTING THE HEIGHT OF THE SENSING SPINDLES

To make this adjustment it is necessary to raise or lower the cam which the sensing spindles are attached to. The
central sensors must be positioned at a distance Y from the surface the caps rest on as indicated in the diagram.
- Position three comparators (1) on the cam (4) at 120° as illustrated in the diagram.
- Reset the comparators.
- Loosen the screws (2).
- Tighten or loosen the grub screws (3) in order to raise or lower the cam (4). All the comparators should indicate the
same degree of movement.
- Tighten the screws (2).
FIGURE 7.5.2 - ADJUSTING THE HEIGHT OF THE SENSING SPINDLES
Position where the
comparators should rest
1 Comparator
2 Screw
3 Grub screw
4 Cam
5 Sensing spindle
Revision 01 Date 14.11.2001
1
•
176.12
ADJUSTMENTS
Y
3
4
2
5
.A03
7
T2509
T0437
7 - 19