2.1.1.10 Pneumatic System; 2.1.1.11 Cooling System; 2.1.1.12 Electrical System: Control Panel; 2.1.1.13 Tools - Sacmi PMV 224 Maintenance And Operation Manual

176.12
.A03
Revision 01 Date 14.11.2001
MAIN FEATURES 2

2.1.1.10 Pneumatic system

The pneumatic system is located in a cabinet housing all the parts for air preparation (filters, pressure regulators,
pressure switches, safety valves) as well as the air-operated actuator controls (solenoid valves).

2.1.1.11 Cooling system

The cooling system is used to supply cooling fluid at a regulated temperature (refer to the work sheet for correct values)
to the following parts:
- Extruder
- Forming unit.
The system includes a chiller (optional) which supplies liquid at a low temperature to the temperature control tanks.
The latter deliver the cooling fluid at the correct flow rates and at a controlled temperature specifically suited for each
point of use.

2.1.1.12 Electrical system: control panel

All information regarding the control panel is given in chapter 6 - OPERATING INSTRUCTIONS and in the Instructions
B manual.

2.1.1.13 Tools

The specific tools installed on the machine depend on the type of product. The tools are therefore explained when the
customer's staff are trained on how to use the machine.
2 - 9