Extruder Base - Sacmi PMV 224 Maintenance And Operation Manual

176.12
.A03
INSTALLATION
4
4.2.2

EXTRUDER BASE

- Bring the base (2) near the unit (1).
- Place the ends (A) of the extruder base (2) on the end (B)
of the drum base (1).
- Lay the other end (external) of the extruder base (2) on
the floor.
- Remove the lifting ropes.
- Attach the lifting ropes as shown in figure 4.2.2/C.
- Slightly lift the extruder assembly (2) and keep it up while
assembling.
- Insert and slightly tighten the screws (C) in the upper and
lower sections.
- Fit the plates (D) beneath the base (2) near the levelling
screws.
- Check the level of the base (2) by placing a spirit level at
a suitable point on the main surface. Adjust as required.
- Check that the base rests perfectly at all points "S" by
using a thickness gauge.
- Fully tighten the screws (C).
FIGURE 4.2.2/C - LIFTING THE BASE
2
D
4 - 6
Revision 01 Date 14.11.2001
Sling C
1
FIGURE 4.2.2/A - EXTRUDER BASE
FIGURE 4.2.2/B - ASSEMBLING THE BASE
2
T0366
2
1
C
A
1
B
S
T2480
S
T0365