Plunger Height Adjustment - Sacmi PMV 224 Maintenance And Operation Manual

7.2.2

PLUNGER HEIGHT ADJUSTMENT

- Remove the screws (1 & 2).
- Pull the blocks (3) away from the cam (4) so that they can be taken off from the bottom.
- Remove or put in the spacers (5) to raise or lower the cam (4), along with the center plunger on the spindle, as required
(each spacer is 0.5 mm thick).
- Reassemble.
The center plunger on the spindle can thus be moved closer or further away (setting "P", figure 7.2) so that the correct
pressure can be applied on the pellet against the bottom of the cap.
FIGURE 7.2.2 - PLUNGER HEIGHT ADJUSTMENT
5
2
3
1
1 Screw
2 Screw
3 Block
4 Cam
5 Spacers
Revision 01 Date 14.11.2001
•
•
•
176.12
ADJUSTMENTS
4
.A03
7
T0425
7 - 9