Installing An 800 Mm Wide Cable Trough; Installing Monitoring Devices; Installing The Sim Card And Antenna - Huawei FusionModule800 Installation Manual

FusionModule800 Smart Small Data Center
Installation Guide (Six Fans)
Step 8 Install the cable trough above the rear door in a similar way.
----End

3.10.3 Installing an 800 mm Wide Cable Trough

An 800 mm wide cable trough (BOM number: 21501140) is installed on the top of an 800
mm wide cabinet. The installation method is similar to the method for installing a 600 mm
wide cable trough. For details, see

3.11 Installing Monitoring Devices

3.11.1 Installing the SIM Card and Antenna

If a subscriber identity module (SIM) card and an antenna are configured, perform the
following steps to install them.
Procedure
Step 1 Record the position of the signal cable connected to the panel of the ECC800 main control
module, and then disconnect the signal cable.
Step 2 Remove the ECC800 main control module, and then insert the SIM card into the left slot of
the ECC800 main control module.
Figure 3-108 Removing the ECC800 main control module
Issue 10 (2019-12-20)
The SIM card needs to support global system for mobile communications (GSM) or wideband code
division multiple access (WCDMA).
Copyright © Huawei Technologies Co., Ltd.
3.10.2 Installing a 600 mm Wide Cable
3 Hardware Installation
Trough.
121