Installing An 800 Mm Wide Cable Trough; Installing Monitoring Devices; Installing The Sim Card And Antenna - Huawei FusionModule800 Installation Manual

FusionModule800 Smart Small Data Center
Installation Guide

3.10.3 Installing an 800 mm Wide Cable Trough

An 800 mm wide cable trough (BOM number: 21501140) is installed on the top of an 800
mm wide cabinet. The installation method is similar to the method for installing a 600 mm
wide cable trough. For details, see

3.11 Installing Monitoring Devices

3.11.1 Installing the SIM Card and Antenna

If a subscriber identity module (SIM) card and an antenna are configured, perform the
following steps to install them.
Procedure
Step 1 Record the position of the signal cable connected to the panel of the ECC800 main control
module, and then disconnect the signal cable.
Step 2 Remove the ECC800 main control module, and then insert the SIM card into the left slot of
the ECC800 main control module.
The SIM card needs to support global system for mobile communications (GSM) or wideband
code division multiple access (WCDMA).
Figure 3-104 Removing the ECC800 main control module
Issue 02 (2016-11-15)
3.10.2 Installing a 600 mm Wide Cable
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Hardware Installation
Trough.
107