[Al1] [A1-L] [A1-H] Alarm 1 Settings (010 , 011, 012); [Al2] [A2-L] [A2-H] Alarm 2 Settings (013, 014, 015) - Fuji Electric Micro-Controller X Socket type Operation Manual

Parameter functions and setting procedure
A1-H Alarm 1 settings (010, 011, 012)
AL1 A1-L
A2-H Alarm 2 settings (013, 014, 015)
AL2 A2-L
[Description] –––––––––––––––––––––––––––––––––––––––––––––––––––––––
Allows you to set the alarm setpoint.
AL1, AL2: Alarm
●
A1-L, A2-L: Low-limit alarm
●
A1-H, A2-H: High-limit alarm
●
Setting range
Absolute value alarm: 0 to 100%FS
Deviation alarm: -100 to 100%FS
When the alarm type ([ALM1], [ALM2]) is set to 0 to 15, you can set the alarm 1, 2 ([AL1], [AL2]).
●
When the alarm type ([ALM1], [ALM2]) is set to any value other than 0 to 15, you can set the upper and lower
●
limits of alarm 1, 2 ([A1-H], [A2-H] and [A1-L], [A2-L]).
Related parameters:
• Alarm type 1, 2 [ ALM1], [ALM2] (see page 49)
• Alarm 1, 2 hysteresis [A1Hy], [A2Hy] (see page 59)
• Delay time 1, 2 [dLy1], [dLy2] (see page 59)
• Alarm 1, 2 options [A1oP], [A2oP] (see page 61)
[Setting example] Setting the alarm 1 to " 20 " ––––––––––––––––––––––––––––
Display
1.
2.
3.
4.
5.
6.
Press and hold the key for about one second during the SV/PV display.
appears.
➔ ➔
Press the key to display
Press the key.
➔ The setpoint starts blinking.
➔
Press the , or
Press the key or wait for three seconds to save the change.
Press the key.
➔ The screen returns to the SV/PV display.
➔
Operating procedure
.
keys to change " 10 " to " 20 ."
28