1-2 Indicators - Fuji Electric Micro-Controller X Socket type Operation Manual

1-2 Indicators

(1) Process variable (PV)
Indicates the process variable. In the parameter setup mode, the parameter name is displayed.
(2) OUT1 indicator
Lights during control output is ON.
(3) EV1, EV2 indicators
Lights during digital output 1 to 2 are ON.
(4) STBY indicator
Lights when the stanby is set to ON. (see page 21)
(5) MANU indicator
Lights during manual mode. (see page 20)
(6) °C/˚F indicator
Shows the temperature unit under use.
(7) A, % indicator
Indicates the unit applied to the value on SV screen during the parameter selection mode and parameter editing
mode.
(8) Set Value (SV) / Manipulated variable (MV)
Shows the setpoint or the manipulated variable. During the parameter editing mode, the parameter setpoint is
displayed.
(9) MV indicator
Lights when the MV is displayed.
(10) Screen No.
Shows screen No. when in parameter setting.
(11) AT indicator
Lights during auto tuning. (see page 25)
(12) RUN/HOLD/END indicators
Lights during ramp soak operation. (see page 22)
(13) KEYLOCK indicator
Lights when the keylock is on. (see page 29)
11
Indicators