Removing The Drive From The Drive Carrier; Installing The Drive Into The Drive Carrier - Dell EMC PowerEdge T340 DPJ1G Installation And Service Manual

Next steps
1 Install the front bezel.
2 Follow the procedure listed in

Removing the drive from the drive carrier

Prerequisites
1 Follow the safety guidelines listed in
CAUTION: Mixing drive carriers from previous generations of PowerEdge servers is not supported.
2 Follow the procedure listed in
3 Remove the front bezel.
4 Remove the drive carrier.
Steps
1 Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
2 Lift the drive out of the drive carrier.
Figure 32. Removing the drive from the drive carrier
Next step
1 Replace the drive into the drive carrier.

Installing the drive into the drive carrier

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the front bezel.
4 Remove the drive carrier.
After working inside your system.
Safety instructions.
Before working inside your
Safety instructions.
Before working inside your
system.
system.
Installing and removing system components 59