Table of Contents
Advertisement
Figure 26. Installing the drive carrier
Next steps
1.
If removed, install the front
Removing the drive from the drive carrier
Prerequisites
1. Follow the safety guidelines listed in
2. If installed,
remove the front
3.
Remove the
drive.
Steps
1. Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
NOTE:
If the hard drive or SSD carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive)
screw driver to remove the drive.
2. Lift the drive out of the drive carrier.
30
Installing and removing system components
bezel.
Safety
instructions.
bezel.
Advertisement
Table of Contents
