Removing The Drive From The Drive Carrier - Dell EMC PowerEdge R240 Installation And Service Manual

Steps
1. Press the release button on the front of the drive carrier to open the release handle.
2. Slide the drive into the drive slot.
3. Close the drive release handle to lock the drive in place.
Figure 22. Installing the hot-swappable drive
Next steps
1. Replace the front bezel.

Removing the drive from the drive carrier

Prerequisites
1. Follow the safety guidelines listed in
2. If installed, remove the front
3. Remove the drive.
Steps
1. Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
NOTE: If the hard drive or SSD carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive)
screw driver to remove the drive.
2. Lift the drive out of the drive carrier.
Safety instructions.
bezel.
Installing and removing system components 29