Feed Correction; Feed Correction Procedure - MIMAKI UJV100-160 Operation Manual

Chapter 2 Printing

2.6 Feed Correction

Changing the media may affect the feed amount due to various factors, including the weight and thickness of
the media and whether the take-up unit is used. Correct the drop position to suit the type of media used.
Image defects (e.g., dark or light streaks) will result if the feed is not properly corrected.
• Is media loaded? "Loading the Media"(P. 53)
• For roll media, is the rear roll media free of sagging?
• When using the take-up unit, was the medium mounted on the core of the take-up unit?
Media"(P. 53)
• The ink used in this machine is warmed before printing. Printing is disabled while the ink is
warmed.

Feed Correction Procedure

Print a correction pattern, then enter the correction value. The value corrected here will also be updated on
the settings menu.
• When using the take-up unit, load media on the take-up unit before correcting.
1
In LOCAL mode screen, select [ADJUST].
2
Select [Feed Comp.], then press the [ENTER] key.
• Correction pattern printing starts.
3
Check the print results.
• A correction value input screen appears.
• Adjust the bands so that the region between them is evenly colored.
4
Enter the correction value, then press the [ENTER] key.
• Enter "+" to increase the separation between bands.
• Enter "-" to reduce the separation between bands.
• Increment the correction value by "30" to move the bands by approximately 0.1 mm.
Check beforehand
LOCAL
width:1340mm
ADJUST DATA CLEAR
Second band
First band
62
"Loading the Roll
Media feed direction