MIMAKI UJV100-160 Operation Manual page 57

18
Secure the medium to the take-up unit.
(1) Press to feed the medium until it reaches the core on the take-up unit.
(2) Secure the middle of the medium with adhesive tape.
(3) Secure the medium on the right and left in the same way.
• Pull the lower edge of the medium evenly on both the left and right sides, check to confirm
that it is free of sagging and creasing, then affix the tape.
• Move the take-up unit to the left or right if not in use. Print quality may be affected if the
front edge of the medium hits the take-up unit during printing.
Adjusting the Torque Limiter
The take-up unit is fitted with a torque limiter. Turn the torque limiter adjustment nut to adjust take-up
tension. The torque limiter is initially set to "Medium" when shipped.
Adjustment nut
Torque scale 50 % of maximum torque
57
Chapter 2 Printing
100 % of maximum torque
2