MIMAKI UJV100-160 Operation Manual page 73

Item
OVER PRINT HOST/1 to 2
Margin/Left HOST/-10 to
Margin/Right
Vacuum HOST/Weak/
Standard/
*3
HOST/10 to
Feed Speed
100 to 200 %
Auto Cleaning
SETUP File/Length/
Time/OFF
Interval
(File) 1 to 1,000
(Length) 0.1 to 100.0 m
(Time) 10 to 120 min
Type Normal/Soft/
Cleaning Check
UV mode ON/OFF/
Setting
*1 *2
• OFF: Machine size area
• ON: Print data area
1 Sets the number of overprinting.
times
0 Sets the offset value from the media left and right standard
85 mm mm margins (15 mm).
• The left and right margins should be set to at least -5 mm when
using the media holder. This eliminates the risk of printing on top
of the media holder.
• The Mimaki RIP software (RasterLink) does not allow the user to
specify margins. If the machine is set to "HOST", the offset value
will be "0 mm" for the left and right margins.
Stro Sets the force with which the medium is held down.
ng
• This can be used to prevent media jamming and print head
Strong damage caused by the media lifting up.
100 Sets the media feed speed.
%
• Depending on print conditions, the speed may not vary for
certain settings.
- - Sets the conditions to perform auto head cleaning after the
preset number of files are printed.
- Sets the conditions to perform auto head cleaning.
- - Sets auto head cleaning intervals.
- Sets the interval at which the number of files is selected.
- Sets the interval at which the print length is selected.
- Sets the interval at which the print time is selected.
- Sets the head cleaning type.
Hard
ON/OFF - Sets whether nozzle checking is performed after auto head
cleaning is completed.
ON Sets whether to turn on or off the UV-LED lamp.
NoPrint
• ON: Turns on the UV-LED lamp.
Details
Unidirectional print
Carriage movement
Unidirectional print
Print data
Carriage movement
73
Chapter 3 Settings
Bi-directional print
Bi-directional print
3