Cap Cleaning - MIMAKI UJV100-160 Operation Manual

5
Clean the wiper and bracket.
• Wipe off any ink adhering to the wiper and bracket using a cleaning stick moistened with washing
liquid.
• Wipe off the washing liquid. Make sure none remains.
• Replace dirty or warped wipers with new ones.
"Wiper Replacement"(P. 104)
6
Reattach the wiper at the original position.
• Do not remove the absorbent material in the absorbent material case. Doing so may result
in leaking ink.
7
Press the [ENTER] key once cleaning is complete.
8
Close the front cover, then press the [ENTER] key.

Cap Cleaning

The cap prevents the print head nozzle surface from drying out. Continuing to use a dirty cap may affect ink
take-up and lead to print defects (e.g., nozzle clogging, deflection).
• Be careful to avoid leaving fragments from the cleaning stick behind when cleaning. These
fragments will increase the risk of print defects (e.g., nozzle clogging, deflection).
1
In LOCAL mode, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
Wiper
Bracket
Lug
89
Chapter 4 Maintenance
4