MIMAKI UJV100-160 Operation Manual page 127

Error Message
number
651 Replace NCU
652 NCU NZK CHK (HW)
653 NCU NZK CHK (Mark)
654 NCU CENTER POS
655 NCU FLUSH POS
656 NCU SN ADJST
657 Replace NCU Ink Pad
658 NCU Sensor Lv Low
65b NCU Sens Adj Err H
65c NCU Sens Adj Err L
702 Thermistor Connect
710 Heater Temp Error
715 InkHeater Thr
716 InkHeater Tmp
717 InkHeater Brk
71a UV-DRV Fuse
901 INVALID OPERATE
902 Data Remain
90d No Head Select
90f Print Area Short
91a Adjust Head Height
b0f DIO PCB Uvpow
b1b BaseIO PCB Vpow-s
b1c BaseIO PCB V24
Cause
• A problem was detected with
the nozzle clogging
assessment.
• A problem was detected with
the nozzle clogging
assessment.
• Printing position adjustment
failed.
• Sensor sensitivity adjustment
failed.
• The NCU ink absorber is full.
• The sensor's sensitivity is
impaired.
• Sensor sensitivity adjustment
failed.
• A problem was detected with
the thermistor connection.
• A problem was detected with
the heater temperature.
• A problem was detected with
the ink heater thermistor.
• A UV-DRV PCB fuse blew.
• The function is disabled due
to an error.
• Print (RIP) data was
received.
• A problem was detected with
the print head.
• The media is too small for the
print.
• The registered print head
height differs from the height
of the actual product.
• A problem was detected with
the UV-DRV PCB power
supply voltage.
• A problem was detected with
the Base IO PCB power
supply.
127
Chapter 5 Dealing with Problems
Corrective action
• The NCU must be replaced. Contact
your local distributor, our sales office, or
service center.
• Clean the NCU. "NCU
Cleaning"(P. 90)
• The NCU ink absorber must be
replaced. Contact your local distributor,
our sales office, or service center.
• Clean the NCU. "NCU
Cleaning"(P. 90)
• Replace the NCU if the error does not
clear. Contact your local distributor, our
sales office, or service center.
• Turn off the power on the machine and
turn it on after a while.
the Power"(P. 31)
• This error will be automatically resolved.
If not,
Turn off the power on the machine and
turn it on after a while.
the Power"(P. 31)
• Turn off the power on the machine and
turn it on after a while.
the Power"(P. 31)
• Check the error details.
• Switch to REMOTE mode and start
printing or clear the data and abort
printing.
• Turn off the power on the machine and
turn it on after a while.
the Power"(P. 31)
• Replace with wider or longer media.
• If the printable area is reduced due to a
shift in the origin, move the origin to
increase the size of the printable area.
• Adjust the print head height.
"Adjusting Print Head Height"(P. 51)
• Turn off the power on the machine and
turn it on after a while.
the Power"(P. 31)
• Turn off the power on the machine and
turn it on after a while.
the Power"(P. 31)
"Turning Off
"Turning Off
"Turning Off
"Turning Off
5
"Turning Off
"Turning Off