MIMAKI UJV100-160 Operation Manual page 56

Chapter 2 Printing
14
Lower the clamp lever.
15
Secure the medium in the media holder.
• Do not use the media holder when printing on thicker media.
16
Press , then select "Roll".
• This starts media width detection.
• If the setting for [Machine Setup] > [Media Detect] > [Detection Type] is "MANUAL", the area for
printing must be determined manually.
• If the setting for [Machine Setup] > [Media Detect] > [Media Remain] is "ON", the media length
input screen will be displayed.
• A notification reading "Media Set Position R" will appear if the medium is too far to the
right of the specified position. Reload the media.
17
Load an empty core on the take-up unit.
Media holder
Core
56
Take-up unit