MIMAKI UJV500 Daily Care Manual
MIMAKI UJV500 Daily Care Manual

MIMAKI UJV500 Daily Care Manual

Advertisement

Quick Links

UJV500 Daily Care
With a view to using this machine in a better condition, please be sure to the following daily care
daily
work. Please refer to "Daily care manual" for the detail.
1. Perform [HEAD MAINT.], move the carriage to the
maintenance position and open the left maintenance cover.
(1) Press the
MAINT.
(2) Press the
(3) Press
(4) Press the
(5) Open the left maintenance cover.
2. Wipe off the ink of around the head and groove with clean stick or waste cloth dipped in
cleaning solution for maintenance.
[Before cleaning]
3. If there is any ink stuck on the bottom surface of the left UV lamp, apply the cleaning
solution for maintenance to a clean stick and wipe the ink away.

4. Open the right maintenance cover.

© 2014 MIMAKI ENGINEERING CO., LTD.
key in LOCAL.
key.
to select [HEAD MAINT.].
key.
• When you leave during maintenance (or cleaning), please make sure to complete the cleaning
by pressing
key. Without completing the cleaning, the nozzle part is left uncovered
and then outside light makes the ink cure, which causes nozzle clogging or the like.
• Wipe off so that cleaning solution
for maintenance will not remain.
Make sure to wear the attached
goggles and glove
[During cleaning]
• When you clean , fully be careful
not to touch the nozzle surface.
M014557-02(D202548-12)-06062014
when you work.
after at the end of the
Left maintenance
cover
[After cleaning]
Right maintenance
cover
IT

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the UJV500 and is the answer not in the manual?

Questions and answers

Summary of Contents for MIMAKI UJV500

  • Page 1 • Wipe off so that cleaning solution for maintenance will not remain. 4. Open the right maintenance cover. Right maintenance cover © 2014 MIMAKI ENGINEERING CO., LTD. M014557-02(D202548-12)-06062014...
  • Page 2  Cleaning of the cap Wipe off the ink of the cap rubber and cap cover with clean stick or waste cloth dipped in cleaning solution for maintenance. [Before cleaning] [After cleaning] Cap rubber • After cleaning, make sure that the cap rubber and mesh in the cap are not removed.

Table of Contents