MIMAKI UJV100-160 Operation Manual page 125

Error Message
number
1e6 PRAM Size Shortage
201 Command Error
202 Parameter Error
206 Printing Mode
304 USB INIT ERR
305 USB TIME OUT
307 MCFD File IF Error
401 Motor X
402 Motor Y
403 X Current
404 Y Current
44e UV Unit Fan Error
44f Take-up Roll Sns Err
48a Detect winding failure
504 CLAMP UP
505 Media Jam
Cause
• Insufficient memory
• Data other than print (RIP)
data was received, or a
problem was detected with
the print (RIP) data received.
• A problem was detected with
the print (RIP) data received.
• Print (RIP) data was received
with print parameters that do
not allow printing.
• A problem was detected with
the USB cable connection.
• A problem was detected
while accessing print
parameter data.
• The X motor was overloaded. 1.
• The Y motor was overloaded.
• An overcurrent was detected
in the X motor.
• An overcurrent was detected
in the Y motor.
• A problem was detected with
the UV-LED unit fan.
• A problem was detected with
the take-up unit sensor
spindle.
• The take-up unit is unable to
take up media.
• The clamp lever is lifted.
• The media jam sensor was
triggered.
125
Chapter 5 Dealing with Problems
Corrective action
• Turn off the power on the machine and
turn it on after a while.
the Power"(P. 31)
1. Clear the data and resend.
2. Check the USB cable connection.
"Using a USB 2.0 Interface
Cable"(P. 33)
3. Use a compliant USB cable.
2.0 Interface Precautions"(P. 33)
4. Turn off the power on the machine and
turn it on after a while.
the Power"(P. 31)
• Change the output parameters and
profile using RIP software.
1. Check the USB cable connection.
"Using a USB 2.0 Interface
Cable"(P. 33)
2. Use a compliant USB cable.
2.0 Interface Precautions"(P. 33)
3. Turn off the power on the machine and
turn it on after a while.
the Power"(P. 31)
• Turn off the power on the machine and
turn it on after a while.
the Power"(P. 31)
Check to confirm the media is loaded
correctly. "Loading the
Media"(P. 53)
2. Open the front cover and check for
anything that may obstruct carriage
movement.
3. Turn off the power on the machine and
turn it on after a while.
the Power"(P. 31)
• Turn off the power on the machine and
turn it on after a while.
the Power"(P. 31)
1. Check to confirm the [Machine Setup] >
[ Feeding/Take-up] > [Take-up Unit]
setting is "ON".
2. Check to confirm the media is loaded
correctly. "Loading the Roll
Media"(P. 53)
3. Check to confirm the take-up unit switch
functions properly. "Take-up
Unit"(P. 24)
• Check to confirm the media is loaded
correctly. "Loading the Roll
Media"(P. 53)
• Lower the clamp lever.
1. Remove the media in contact with the
carriage and reload with fresh media.
"Loading the Media"(P. 53)
"Turning Off
"USB
"Turning Off
"USB
"Turning Off
"Turning Off
"Turning Off
"Turning Off
5