Figure 6-92: Check Relationship Between Roller Arm And Pin In The Detent - GE Discovery LS System Service Manual

GE H
EALTHCARE
D 2307224-100, R
IRECTION EVISION
4.) Refer to
0.5 mm should exist between the roller arm and latch pin.
5.) If the roller arm touches the latch pin when the roller is in the detent:
a.) Move the table away from the detent.
b.) Use a 4 mm Allen wrench to remove the existing M5 detent hardware.
c.) IMPORTANT: Add one shim, and refasten the detent in place with the M5 22 mm
d.) Repeat
e.) If the roller arm no longer rests against the latch pin when the roller is in the detent, count
CAUTION It is possible to add too many shims, and destroy the gas spring.
maximum acceptable distance between the roller arm and latch pin. Shim for the minimum
clearance between the arm and pin.
Page 176
6
Figure 6-92. Push the table into the detent, and check the roller arm. (A gap of at least
Roller arm should not touch latch pin when roller is in the detent.

Figure 6-92: Check Relationship between Roller Arm and Pin in the Detent

hardware. Add only one shim at a time during this procedure.
Step 2, Step 3 and
shim and repeat the process.
the shims added, and fasten the same number to the remaining detent.
Chapter 6 - Table
Roller arm shown at maximum distance.
Step 4. If the roller arm still rests against the pin, add another
D LS S S
ISCOVERY YSTEM ERVICE
Figure 6-92 shows the
M
ANUAL