Attach Clutch Motor Cables; Figure 6-66: Attach Adhesive Mounts To Front Of Table Rail; Figure 6-67: Clutch Motor Cables - GE Discovery LS System Service Manual

GE
HEALTHCARE
D 2307224-100, R
IRECTION EVISION
4.) Refer to
table rail. (If possible, align each adhesive mount to a pre-drilled and tapped M5 hole.)
5.) Orient the mounts vertically as shown in
a good grip.
6.) Use M5 screws to fasten the three mounts to the rail at the front of the (Revision 3) table.
Note: If the rail does not have pre-drilled mounting holes (Revision 0, 1, and 2 tables), use the adhesive
mounts without the M5 screws.
6.2.6.23

Attach Clutch Motor Cables

1.) Locate and remove the following cables from the upgrade kit:
2323729
2323726
2323720
2.) Refer to
bracket fastens to the Clutch Motor casting.
6
Figure 6-66. Attach three tie-wrap mounts, P/N 46-208747P2, to the front end of the

Figure 6-66: Attach Adhesive Mounts to Front of Table Rail

Part Number
Base Potentiometer E Cable
Clutch Control E Cable
Base Axis Motor E
Figure 6-67. Attach the cables to the Clutch Motor bulkhead bracket. The bulkhead
Clutch Motor Bulkhead
Bulkhead Ground
Ground from J3 Connector

Figure 6-67: Clutch Motor Cables

Chapter 6 - Table
D
ISCOVERY
Figure 6-65, and wipe the area with alcohol to ensure
Description
LS S S M
YSTEM ERVICE ANUAL
Page 159