Install Clutch Driver Unit (P/N 2340282); Figure 6-43: Install Clutch Driver Unit; Figure 6-44: Clutch Driver Unit - GE Discovery LS System Service Manual

GE H
EALTHCARE
D 2307224-100, R
IRECTION EVISION
6.2.6.14

Install Clutch Driver Unit (P/N 2340282)

Follow the instructions in this section to install the Clutch Driver Unit, P/N 2340282.
CAUTION Refer to
space provided by filing the holes or grinding the edge of the bracket. Be careful when filing
or grinding. Cover the top of the unit to prevent metal filings from entering the unit and
causing shorts. The unit uses 120 VAC..
1.) Use a 5 mm Allen wrench to fasten the Clutch Driver Unit into place with the following
hardware:
• Two M6 x 16 mm screws, P/N 46-214695P34
• Two M6 lock washers, P/N 2315373-4
• Two M6 flat washers, P/N 2109878-3
Note: The J18 and J221 cable connectors are mislabeled on the Clutch Driver Unit. Refer to
Use a permanent marker to cross out the original labels and relabel the connections on the face of
the unit.
2.) Attach the connector labeled J221 to the connector relabeled J221 (formerly J18) on the
Clutch Driver Unit.
Page 146
6
Figure 6-43. The Clutch Driver Unit bracket may require modification to fit into the

Figure 6-43: Install Clutch Driver Unit

Relabel this connector J221.
To AC Filter
Relabel this connector J18.

Figure 6-44: Clutch Driver Unit

Chapter 6 - Table
D LS S
ISCOVERY YSTEM
Clutch Driver Unit
Bracket may need modification.
Use a 5 mm Allen wrench and
fasten with M6 hardware.
S M
ERVICE ANUAL
Figure 6-44.