GE H
EALTHCARE
D
2307224-100, R
IRECTION
EVISION
6.2.4
Mechanical Installation
There will be parts left over after completing this upgrade.
6.2.4.1
Remove the Table Covers
1.) Refer to
guidelines to discard or recycle the metal base covers.)
2.) Refer to
a.) Use a 4 mm Allen wrench to remove the two screws that fasten the window shade roll-up
b.) Remove the hardware that fastens the window shade roll-up cover to the bulkhead
c.) Follow local guidelines to discard or recycle the window shade roll-up cover.
Page 114
6
Figure
6-1. Remove all the metal covers from the secondary base. (Follow local facility
Figure 6-1: Remove Metal Covers from the Secondary Base
Figure
6-2. Remove the window shade assembly from the front of the table base.
cover to the front of the table secondary base.
bracket. (Leave the bulkhead bracket in place for now.)
Use 4mm Allen wrench
to remove hardware.
Do not remove Bulkhead
Bracket at this time.
Figure 6-2: Remove Secondary Base Front Roll-up Cover
Chapter 6 - Table
D
LS S
ISCOVERY
Window Shade Roll-up Cover
S
M
YSTEM
ERVICE
ANUAL